FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I have an 01 glastron with a 4.3gl, I replaced the block and heads with a re manufactured engine. Ran fine for about 40 hours. Now when giving it gas while underway it will start popping. I can punch it out of the hole and it will rev right up to 4400, will not pop until 15 or 20 seconds. I can...
need some help here, I ordered a new raw water nipple for my 02 sx-m drive 1.79 serial #4202076669. part # is 3807819 and it is to large, the part # printed on old nipple is 917119. The nut size on the old one is 1 1/8, and the hose size is 1 1/8. the new one is 1 1/4 both sides so there is NO...
I am new to the forum and wanted to share what I did to my Glastron. I bought this boat March 20, 2016 on ebay for $5600 with a trailer and only 149 hrs on a Volvo 4.3 gl. I got this to get back into wakeboarding so I needed to add a tower and a swim platform, among other things.The boat was in...
I have an 02 Glastron that I purchased 2 years ago with a 4.3 Volvo with the penta sx-m. My gimbal bearing started to go and long story short,removing the drive I broke the upper bearing carrier. Snapped all 4 bolt tabs off, took the pivot unit off and pressed the carrier out. Now what is my...
