Recent content by Craig Winnerman

  1. C

    intermittent up tilt/trim relay on S150TXRW

    I have a 1998 Yamaha S150TXRW. Motor trims down no problem from both throttle and motor switch. From both switches when triming up, relay clicks. If you keep hitting the up switch rapdily, the realy will catch and the motor will trim up. Can the blue trim relay have an intermittent problem...
  2. C

    Yamaha wiring harness

    While redoing my gauges in my 1997 S150TXRW, I noticed the wires the stock wiring harness are not tinned, but just plain stranded copper. They are also all 18 awg. I have read that all wiring for marine applications should be at least 16 awg and always tinned. Why does the Yamaha harness not use...
  3. C

    Trim problem after conversion to analog gauges

    I just replaced my digital gauges with Teleflex Analog gauges. All is fine except for the trim will not go up. I did get a pre 2001 Yamaha trim gauge made for 3 wire. The trim will go down from throttle button, but not up. At the motor trim switch the engine will go down as well and you can...
  4. C

    Question for Rodbolt

    Hey Rodbolt, I am new here and have enjoyed reading your post and even your humor. I am going against your advise and replacing my multifunction tach and speedo gauges with Teleflex Lido analog gauges-Tach, Speedo, trim, water temp, fuel, volt and hours meter on my 1997 S150TXRW with 704...
  5. C

    Conversion to analog gauges

    I have a 1998 Yamaha S150TXRW. I currently have the multifunction Tach and speedo. The tach is no longer visible and wish to replace both the tach and speedo with Teleflex Lido analog gauges-tach, speedo, trim, volt, water temp, and hours meter. I am designing a new dash from...
  6. C

    Faulty Keyed ignition switch help

    I have a 1998 Yamaha 150 S150TXRW. The ignition swithch assembly part #704-82510-02-00 is failing quickly. While awaiting for the part to arrive, how can I hot wire it if I get stuck. When you turn the key sometimes no power to dash, sometimes power to dash and will not turn over, sometimes...
  7. C

    Thru Hulls for 1998 2201 Century Bayboat

    I have a 1997 Century 2201 bayboat center console. The original plastic Thru hulls connected to the cockpit scuppers are very worn and i would like to replace with Stainless Steel. The original thru hulls are a very unusual shape to make them very low profile for the 90 degree bend. Using a...
See more
Top