Wondering if this would cause my johnson gt 150 to take around 10 seconds to get on plane? Motor is mounted on a 5 inch jack plate, and has a step in the hull. Center prop shaft is about 6 inches below hull and the plate is about inch and half above. Should I raise it an inch?
I'm not sure if the hoses where replaced in the correct places for the recirculating valves on my 1988 johnson gt 150. Does anyone have a diagram, my manual does not.
I have a 1988 johnson gt 150 that that has been running a little lean and ruff at idle. Also when i accelerate it takes a while to plane ( 8sec on 17ft bass boat) and wot is around 4400 rpms. So today i checked for leaks. I took a soapy sudsy solution around everything to check for leaks. The...
I had many little issues I've tried to nip, now there's another. I'll start with what I've done.
Had a spark not firing, so replaced coil, now works. Had leaking fuel lines, replaced them all. Cleaned carbs and put new kit on them as well as a link and sink. Replaced regulator, rectifier...
I have a 1988 johnson gt 150 on a 1989 nitro 1800tf (17ftbass boat). The idle is a little low but it sounds like it runs good through all rpm ranges. I have tried 2 props. First one is a 14 1/2 24p raker. When I throttle , i hear the the engine rev up nice and fast, but the rpms on the tach...