Bondo's latest activity

it's gone --- once available stock is sold engine coupler grease - gone u-joint and gimbal bearing grease - gone Special Lube 101 - gone...

Today I went out crabbing for 3 hours. No oil burn from yesterday and today. I’m going to install a catch can system to each valve cover...

additional research shows that the part number 87-81428A5 is listed as a normally open switch , this type applies a ground to the...

And...are you sure there isn't a pipe plug in the front and rear of the exhaust manifolds? This is how all the other Barr manifolds I...

Yes, a problem. You missed something. But you did real good checking like this. That's how a seasoned tech checks their work. Should...

Good thing to know,.... Thanks BD,.....

Should your switch go bad/not working you can update to the newer style with a small wiring mod. Remove and tape off the Green /White...

Steven King must have had something to do with it. 👍

Ayuh, exactly right,....

No, there's no chance of prefect seal(aka: permatex form-a-gasket #3) going anywhere, other than where you paint on on,... If yer...

Replacing those parts, isn't take the old one out/off, put the new one in. There are Shims in there to adjust the Gear Mesh, perhaps...

Tap method doesn't work until long after the wood is wet, rotten, and eaten by insects, then dries out leaving a void Chuck up a 5/16"...

Ayuh,..... What other engine,.??..??

Hey y'all!!!! I wanted to come on and thank you so much for the help. I ended up replacing the fuel filter, both fuel pumps, then the...