Hey guys have a good one for yah buddy of mine is repowering from a 60 Johnson 2 stroke to a suzuki 90 but the one side of the transom is soft were the old owner had a kicker plate wondering if someone can help me figure out how to change transom in this old boat
Hey guys looking for some direction i am parting out my boat and looking for a newer one as I don't have time to do the stringers and all what do u i think I can sell my running merc 165 inline six it ran like a champ in may I believe it is a 73 to 78 thanks for the advice
Ok guys I need some advice I had to cut my new transom in 2 to get it in the boat as I am not doing a top off reconstruction is this ok it is holding an mc1 and a merc 165 i/o. I cut the wood to line up right in the center of the key hole..
Thanks guys for the advice
Hey guys getting ready to start the new transom in my mfg I know epoxy is the way to go but the boat is poly should I go poly or epoxy trying to keep the cost low as I have alot of patches to do any input would be great
Hey guys been looking all over the place for answers and can't seem to find what I am looking for.. I have a 84 mfg with a 165 merc with an mc1 the boat was in storage for a few year been posting alot about it. So we finally got it out this weekend ran like a brand new motor thanks to the guys...
Hey guys new to the forum I purchased a 1984 mfg caprice 19ft bowrider with a merc 165 inline 6 I drain the old fuel replaced the trim pump and was ready for the first run on the muffs. Turned the key and it cranks very well and nothing not even a burb check for spark and no spark getting...