FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Hi I went back and fill tank with oil and jump wired the motor and the motor will run but not pumping any so I believe it is the oil feed pump
6E5-81900-01-00
Until I get a answer
Hi I have a 2004 Yamaha 115 115TXRC and this morning I was headed out fishing and my alarm came on I think low oil, when I got it home and tried to prime it with switch at tank it would fill it and I couldnt hear motor on the fill tank running, so I pulled tank out and removed motor and hooked...
Hi I have a 2004 Yamaha 115 mod no.115txrc, and today when I was backing the boat in the river it kept bogging down when given more gas, but when I finally got in river it ran find all day until I tried to reload on trailer and i give it gas to push the boat it just bogs down and shut, finally...
Hi I am looking to upgrade to a newer fish finder and im looking at a Garmin ECHOMAP UHD 74sv Fisher and a Humminbird Helix 7 CHIRP MEGA SI GPS G3N GPS Fishfinder trying to see which would be better since I can get both at around the same price, anyone have any knowledge of them
I have a 18.6 bowrider used in mostly salt water, the anchor came with boat will not hold in sandy conditions , it has a no. 11 stamped on it with sliding ring is this a 11 pound anchor and should I go to a 13 or 15 pound anchor
I have 2004 Yamaha 115TXRC and when trying to cold start it will not crank, I can pull the manual choke on outboard motor and it starts right up, I can here the solenoid click in operation but seem to not be getting the gas
I have a 1999 90hp Johnson and the pump and motor work good on t&t but the up button on the shifter dont work , the down and trailer buttons work up and down
I have a 1999. Johnson 90hp and engine is not starting because of sitting awhile, I would like to know of a way to clean or soak carbs without removing them, I have spray and seafoam,
I have a 99 ezloader trailer for an aquasport and I need 2 crossmember that are bent on approximately 20 degree and about 62 inches long where would be the best place to find them, they are open ended and 2x3 inch
I am looking at purchasing a boat with a 2004 Yamaha 115 2 stroke and the guy says boat has 190 hours, is that low hours, the boat and engine look excellent