Recent content by Backlash

  1. B

    Replace Padded Side Panels

    Hi Guys, Looking for ideas on what to use to replace the padded side panels on my 1990 Seaswirl Striper. I've been kicking around the idea of using Starboard but the cost is a little steep. Just want something that looks a little more "modern" that the padded stuff. Thanks, Backlash
  2. B

    SS vs. Aluminum

    In switching from aluminum to stainless steel...should I figure on the same pitch? I currently have a 15x17 aluminum which seems just about right for the current setup. I've heard the diameter doesn't make too much difference (as long as it clears the cav plate). True? Thanks, Backlash
  3. B

    '83 B100 Impeller Replace

    Need to replace the impeller on my B100. All posts I can find refer to disconnecting the shift shaft by loosening a "locknut" midway down the housing. My shift shaft runs through a solid housing and is "invisible" all the way down. Can anyone offer the procedure for disconnecting the shift...
  4. B

    Radar Arch

    I have a 1989 Seaswirl 210 WA. I want to mount a radar antenna. Any suggestions as to where to buy, what type arch, etc. I have a Raymarine radar antenna. Thanks, Backlash
  5. B

    Hard Starting Force

    Hi Guys, A buddy has a '88 85hp Force with the following symptoms: On the first start of the day, or after it has cooled down on the water, it won't start without first spraying pre-mix into the carbs. Once started it runs great. He has rebuilt the carbs, checked the fuel system from tank to...
  6. B

    No Oil Alarm

    I have a 1989 Johnson 150 with VRO. Recently the "no oil alarm" sounded while I was running. I stopped the motor and used my kicker to get back in. I have tightened all fuel & oil line connections, examined all hoses & primer bulbs for both the oil & fuel. I premixed and took it out again. I...
  7. B

    Fuel Filter/Water Separater

    I run a 1989 Johnson 150 and a 1983 Honda 10 hp kicker on my 21' Seaswirl Striper. I have installed a fuel filter/water separater and have the fuel lines from both engines coming off this single filter. Is this a problem? Somebody told me I should have a switch to select which engine should...
  8. B

    '89 Johnson 150 Alternator Output

    Hi guys,<br />I'm at work and don't have access to my manual but the question has come up about alternator output. Anybody know what the output amps are on my 89 Johnny 150?<br />Thanks a lot.
  9. B

    '89 Johnson 150 Bearing Carrier

    Hi All,<br />Trying to get the bearing carrier out of the lower unit so I can change the prop shaft seals. Have removed the 4 retaining screws and I have a puller on it.....it won't budge. Have tried heating the housing up with a propane torch and still can't get anywhere. Any ideas?<br...
  10. B

    Year of Honda 10 HP

    In a previous post, I listed my Honda 10 HP as a 1983. That's what I was told by the previous owner. It's a B100S 1501819. zzzzz or anyone else, can you verify the model year for me?<br />Thanks in advance,<br />Backlash
  11. B

    Conversion to Long Shaft

    I have a '83 Honda 100 (10 HP) that I would like to convert to a long shaft. Does anyone know of a conversion kit for this motor?<br />Thanks,<br />Backlash
  12. B

    RF Ground

    I'm installing my new Raymarine C-80 system and the instructions say, "it is important that an effective RF ground is connected to the system. You can ground the DSM300 by connecting the drain wire of the power input cable to the boat's RF ground."<br />I assume RF stands for "radio frequency"...
  13. B

    Mayfair Bilge Pump

    I want to upgrade my bilge pump to a Rule 1500. The current pump is extremely hard to get at but using a mirror & flashlight I can see it's a Mayfair. The problem I have.....I can't seem to figure out how it's mounted in there and can't get it out. I can reach it with one hand and can turn it...
  14. B

    Crossflow/Looper

    What a great site! I've been visiting for quite awhile and have learned alot from y'all. My question is....can you tell a crossflow from a looper just by looking at the engine? I just bought a 89 or 90 Johnson 150 and was wondering which it is. Thanks in advance.<br />KingFisher5
  15. B

    Blackmouth Fishing

    Any good reports on the Blackmouth fishing in Puget Sound? Haven't been able to get out since the season opened on the 1st. Normally try for them off Port Townsend. Have heard of some fish being taken in the San Juans.<br />Backlash
See more
Top