Recent content by alexandery

  1. A

    2004 Yam F225 4 Stroke

    Thanks for reply have ordered the seals will take my time hopefully no problems
  2. A

    2004 Yam F225 4 Stroke

    I already repaired the outer trim seals dont know if tilt rod and piston will have enough room to be removed in place will it hit the motor ?
  3. A

    2004 Yam F225 4 Stroke

    Can you replace all 3 trim and tilt cylinder seals without taking trim and tilt assy off motor,
  4. A

    trolling motor shaft extending

    can you extend a 50 inch motorguide shaft 1 need it about 8 inches longer
  5. A

    04 yamaha 225 4 stroke charging

    04 yamaha 225 4 stroke can i use the charging system to charge my 3 trolling motor batterys when running the outboard
  6. A

    Not Charging

    04 Yam F225 Charges 14.0 Volts For About 2 Hours Of Running Then Drops To 11.10 Volts If I Turn Off And Let It Cool Down It Starts To Charge Again For A Period Of Time
  7. A

    trolling motor

    I Am Trying To Install A Motor Guide Trolling Motor To My 2004 Triton 22 Lts But The Boat Has A Small Step Up Where You Would Mount The Base And It Is Only 3 Inches Wide And The Mount Is 6 Inches Wide Has Any One Any Options
  8. A

    water pump 250 yamaha

    I Have A 2002 250 Yamaha Ox66 Saltwater Series I Am Going To Replace The Water Pump Assy I Have Done This Repair On A Johnson And A Mercury Before Is There Any Special Tools Or Procedures I Should Know About
  9. A

    Trolling Motors

    I Purchased A 2004 Triton 22lts It Has The Plug Up On The Bow For A Trolling Motor. It Only Has 1 Battery And Has Room For 2 More Can I Put A 24 Volt Or 36 Volt Trolling Motor And How Difficult Will It Be To Hook Up
  10. A

    trolling motor

    i purchased 04 triton 22lts it has a bow rail approx 6 inches high i would like to install a trolling motor but cant figure how to without removing the bow rail has anyone seen this set up thanks
See more
Top