Hi Folks, Would like to put this out there to see what i can find out. I was doing some other routine maintainence on her yesterday and came across
a line what appears to be a oil line that's been cut off, it has a tie-wrap on it but cannot find the other half to it. I consider myself an...
Hello all, I've been in and out of my motor for the past 2 weeks and I cant seem to pin point my issue. If some has had this same problem can you shed some light towards a 15 year boat captain that's dumbfounded. HA
OK here goes: At Initial start motor continuously cranks, once I select...
Hello, I want to get some opinons on the E-tec motors. I'm currently looking at a boat with 2 Etec's. Are you happy with them? Any real issues with the motors? Thanks in advance.
Chris
I just changed my Fuel/Water Separator I have in-line between the eng & tank. The ball is tight, the engine will run for 4 min then quit. Ball is still tight. Any suggestions? Thanks in advance.
Chris
I just came back from the sandbar. I have a 2005 Merc 250 EFI Saltwater. I noticed the pin that holds the ram cylinder in place is 3/4 out and bent, Its just hanging on... How would one attack this problem? Can I purchase just the pin and re-install it? Any advice would be greatly...
