Hi everyone,
My Merc 01 Carbed 150 hp is at 2.1 MPG (4300lb boat). How much improvement would a Opti or a Verado make? My 01 outboard runs like new. Would hate to switch, with out a significant improvement in MPG's.
Thanx in advance!
Joe
My 2001 150 hp leaks gear oil out the vent hole. It leaks out the hole adjacent to the oil screw fill hole. Freshly filled 25 hours ago. This occurs after running the engine on the garden hose, and in gear at low idle. Any suggestions on how to stop the gear oil from leaking out this vent hole...
Why wouldn't my Force 120 Start?
I wore ouy my starter trying to figure this one out, gave up and brought it to an outstanding free lance merc mechanic here in San Diego.
Slight corrosion on the black thick electrical connector by the spark plugs, shut me down. He seperated them and put...
I put 15 gals of 2 year old gas into my perfect running 1999 120 HP force. My motor quit working. it turns and has a spark but, absolutely does not catch. Kill switch is not a factor. Fuel filter looks clean.
Any ideas to get her running are welcome!!
Thanx!
Hello everyone,<br />I'm considering purchasing a used 2000 model year, 175hp 2 stroke yamaha. Is this a good engine or not so good. Is yamaha the type of company that stands behind their products?. I'm currently using a Mercury Force 120 HP(500 hrs of salt water use, runs perfect. I do a lot of...
Hi Everyone,<br />I recently overheated my 99 Force 120HP outboard. My overheat warning horn went off, after keepng it, at full throttle for to long (not near max RPM either). Is there a way to test the overheat sensor?<br />Thanx<br />Engine compression checks good 150/150/150 and 145psi. No...
My 1999 Mercury force 120HP's rpm drifts,this occurs at constant throttle and engine sound. This leads me to believe it's an indicator problem. I believe there is no direct cable from engine to dash board. So I may have a problem with a voltage regulator, or my charging system. Does anyone know...
My 1999 force 120HP's rpm drifts,this occurs at constant throttle and engine sound. This leads me to believe it's an indicator problem. I believe there is no direct cable from engine to dash board. So I may have a problem with a voltage regulator, or my charging system. Does anyone know how I...
Our top notch outboard mechanic here in San Dog, says, the average 2 stroke can last for 1500 hrs of salt water use. 3000 hrs of salt water use, is the best he's ever seen. <br />Whose got the longest lasting out board out there?<br />I'm at 500 hrs on a 99 Force 120hp, mfg by Merc.
Our top notch outboard mechanic here in San Dog, says, the average 2 stroke can last for 1500 hrs of salt water use. 3000 hrs of salt water use, is the best he's ever seen. <br />Whose got the longest lasting out board out there?<br />I'm at 500 hrs on a 99 Force 120hp.
Hi gents,<br />I replaced the internal gaskets,rubber and springs on my engine's fuel pump after 500 hrs and 6 years.<br />Bottom line the old stuff looked great. I could have postponed this for some time. But, better safe than sorry.
I installed new bearings and thought I was good to go. I noticed my wheel whobbleing at 50 mph. slowed down to 20 mph, and made new friends on the CA interstate. Limped home on secondary roads. I experienced a bearing failure. The bearings were brand new 10 months earlier. I thought I had...
Hi Force affectionados,<br />My 1999 120 HP Force is underpowered for my ****ed out 22 Foot Trophy (a lot of extra weight). I need more HP. It currently runs perfectly. When it's time, is it possible to rebuild it with more than a 120 HP? Thanx in advance!!
Hi boaters. My boat hit hit the bait barge a lttle to hard. What's the best way to repair a surface scatch? Is there a paint that I could apply? Any advice is appreciated.