Stealthtocontact
Recruit
- Joined
- Sep 20, 2020
- Messages
- 5
I have searched and searched but I'm hoping you can answer my question specifically. I have and 1983 OMC Stern drive. It will not tilt up or down I replaced the cell annoys because I found one of them was cracked. I tested the tilt motor, By bypassing the shell annoyance and learned to the motor was not responsive, So I pulled the motor and bench tested it to confirm and have ordered a New one in the meantime I attempted to raise and lower the out drive after greasing Trunnion And was unable to lift or raise the outboard I removed the clutch pack cleaned it and the clutch housing put new Lubricant and re installed snap rings both looked good Still can not raise or lower the out drive when the worm gear is when the clutch pack is installed with no worm gear it roles perfectly. Pulled the worm gear replaced it with a new shaft still no movement when fully assembled. I met my wits and please help