1988 Evinrude 88hp slow cranking with dim lights

Status
Not open for further replies.

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
A couple guys will tell you how to take it apart And replace brushes and what not. Stupid simple. You need to do a couple ohm readings before you bother though
 

derek4325

Petty Officer 2nd Class
Joined
Mar 7, 2015
Messages
167
Well it sounds like you did all you could do with it so far. Just as long as you tested it eliminating all other components in the path of current except for the starter and the battery. I couldn't give you a specific description on how to change the brushes or where to find a new starter. May want to do some research as to how to do that or maybe start a new thread. But you most likely have a model number on your block somewhere. It will be on a "freeze plug" looking thing. About the size of a quarter. Not sure if that particular motor has one or not but it's a good place to start.

MOD EDIT - iBoats has the part, no need to direct sales to a competitor. You know, the folks who sponsor this free forum and offer price matching and a 5% discount to forum members. http://www.iboats.com/BRUSH-SPRG/dm/...iew_id.1492743
 
Last edited by a moderator:

Soundpuke

Cadet
Thread starter
Joined
Aug 4, 2017
Messages
7
New starter installed. Boat cranks over fine on the ears and runs good in the driveway. Tomorrow another lake test - last time it ran fine in driveway but couldn't for the life of me get it going while at the dock! Got more issues me thinks!! Local place sold me the starter for 98 dollars. Studying 88hp SPL start procedure intently!
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
Cold start procedure is pretty easy:

- attach fuel line and pump bulb until firm whilst holding the motor end of the bulb upward
- lift fast idle lever to max
- turn key to run position, press key inward (energises primer) then turn key to 'start' position and crank until motor catches/runs
- dab key inward as needed to keep motor running, lowering fast idle lever as it warms up

Warm starts usually need no priming, just raise the fast idle lever a bit then crank it over.
 

sqzdog

Cadet
Joined
Jun 16, 2018
Messages
16
New starter installed. Boat cranks over fine on the ears and runs good in the driveway. Tomorrow another lake test - last time it ran fine in driveway but couldn't for the life of me get it going while at the dock! Got more issues me thinks!! Local place sold me the starter for 98 dollars. Studying 88hp SPL start procedure intently!

I have the same engine with the same slow cranking. Can you update us as to what you ended up finding out to fix the problem?
 

GA_Boater

Honorary Moderator Emeritus
Joined
May 24, 2011
Messages
49,038
I have the same engine with the same slow cranking. Can you update us as to what you ended up finding out to fix the problem?

The OP left the forum instead, so no answer coming from him. Please start a new thread.

Closed.
 
Status
Not open for further replies.
Top