Search results

  1. A

    VRO Ticking? w/ video

    Hi - I have a 1998 175hp Johnson looper. I am having trouble chasing down a stalling issue. When I put the engine in gear, at the lowest rpms it sputters and dies. Pumping the ball helps so I think it was the VRO. I had an older VRO sitting around from another engine (1992) and I swapped it out...
  2. A

    What is this part? 2006 115 Tohatsu

    2006 Tohatsu 115hp I just got this engine and it overheated. I made a mistake when looking for the thermostats and pullted this part out, and a bunch of springs/washers came out with it. Any idea what it is so I can find a diagram on how to put it back together? Also, any reccomendations on...
  3. A

    70s Lightwin 4hp General Info

    Hi - I just picked up a dinghy and 2 older Evinrudes came with it. I believe that one is a '72 and the other a '76. The '72 runs pretty well and the '76 (according to the seller) needs a new coil and pull start cord. The Achilles dinghy and 2 motors were pretty cheap and should be fun to play...
  4. A

    How to test a 2 wire temp sensor?

    Hi - Apologies if this has been asked before, but I couldn't find a thread. I know how to test the 1 wire temp sensor on the right side of my 150 Johnson ocean runner, but not the left 2 wire side. it is a 1992 looper. What does the second wire do, and how do I ohms test this sensor to ensure...
  5. A

    Guess That Alarm!

    https://youtu.be/i_3wv2j9FeA I have a 1992 Johnson Silver star v6 looper. I am getting an alarm i do not recognize. What do you think it is? The oil tank is disconnected and I premix 50:1. It’s pissing cold and does not seem to be running lean or overheating.
  6. A

    150hp Stalling only when warm - Coils?

    Hi, I am looking for a place to start with a stalling issue I am having with my 1992 Johnson 150hp. The engine is new to me and has good compression. I have taken it out two times so far and each time it has run perfect until the end of the day after a long idle.The ball gets hard when I pump...
Top