Search results

  1. Dave Abrahamson

    2001 Evinrude 115 non FICHT?

    Reporting my boat and a shop says he has an Evinrude 115 with carbs. Did they also make carburetor engines in 2001? Haven't gone to look at it yet. Thanks
  2. Dave Abrahamson

    Frozen midsection steering bracket?

    Hi Guys, I have an issue with my 1997 Johnson 115SPL model#J115hxeua. The motor will barely turn when disconnected from the steering cable. Cable and helm are fine. I've already replace one helm due to stiff steering and I want to avoid that again. I'm trying to pump grease into the steering...
  3. Dave Abrahamson

    Looking to upgrade..

    Hey Guys, I currently have a Magic Tilt Galvanized trailer under my 20ft cc Angler. I would like to stay with the single axle configuration but switch to aluminum. I'm in the Safety Harbor , FL area. Any and all advice/suggestions would be most appreciated. Thanks Dave
  4. Dave Abrahamson

    Rotary steering replacement -UPDATE W/PICS

    Hey Guys, I have an older (1998) Morse/Teleflex rotary steering helm which I believe is a Command 290. The cable (which is fine) is #304411 204IN 7226. Do you know which helm is compatible with the existing cable? It's on a 20ft center console with a Johnson 115 if that is of any help. Thanks...
  5. Dave Abrahamson

    Head bolt size?

    Does anyone know the size tap I should use to clean up the threads in my block before putting the heads back on? I did break one bolt taking the heads off and I can't get it to come out with PB blaster, heat and vice grips on the little bit of bolt that's left sticking out. I'm going to have to...
  6. Dave Abrahamson

    Head gasket?--(w/pics) UPDATE

    1997 Johnson 115SPL J115HXEUA Overheated a few times while scalloping due to major floating grass everywhere. The motor now gets to maybe 3000 RPM and falls on her face trying to plane out. Went to check coils with a spark tester and found this when I pulled the bottom port cylinder spark plug...
  7. Dave Abrahamson

    Mystery residue

    1997 Johnson 115SPL model J115HXEUA I was installing a new pump kit on my motor and found a white powdery/granular residue packed into the area circled in red. It was packed solid. This was my first pump install so i wasn't sure if this is normal or not. Anyone else seen this before? Was it...
  8. Dave Abrahamson

    Patio Umbrella base suggestions

    Hey Guys, I have a 20 foot cc with a bimini, but it doesn't quite cover the bow area. We go out scalloping and the sun can be brutal for the kids up front. Everyone can't fit under the bimini. It would only be used at anchor,and be stowed when under power. Last year I lashed a pvc pipe to the...
  9. Dave Abrahamson

    Part number help

    Hopefully one of you guys can help me out. Is the part that I have circled part #0432572? Cam Roller? I found some broken pieces in the pan under the linkage and it appears to have come from the part I have circled. What could be the issues of not having the complete assy. It looks like the...
  10. Dave Abrahamson

    Alaska on a budget?

    Hey Guys, My wife and I are contemplating a trip to Alaska. Has anyone been to a nice fishing lodge up there that isn't a thousand dollars a night...or am i just wishfully thinking? I would prefer one that isn't a tour bus type thing, more of a lodge on a lake or river. Thanks for any and all...
  11. Dave Abrahamson

    Prop rehub Tampa Bay area

    I spun my spare aluminum prop so I'm looking for a good place to take a prop for a rehub around the Tampa Bay area....any suggestions? What's a fair price, ballpark? Thanks, Dave
  12. Dave Abrahamson

    Drain Hole??

    I had a rear crossmember replaced due to rust . It seems they used a steel 3x3 and painted the galvanizing spray on it. I know it won't be as good a repair as I would have liked, however, they neglected to drill a hole at the low point on the crossmember....should I go ahead and put a drain hole...
  13. Dave Abrahamson

    Losing rpm's+mph

    Hey all 1st time poster here in i/o. My BIL (up in NH, so too far away for me to be of much help except for you guys here on the forums),has a Trophy 2052 cuddy w/ a 4.3 merc that has lost about 6-800 rpm's wot. 45mph down to around 30ish mph. His mech said to drop from a 19p to a 17p prop, but...
  14. Dave Abrahamson

    backwards cables....doh!

    Don't ask....I know!!...I asked myself the same question.... Anyway... I managed to connect the battery cables backwards on my j115 spl '97 and turned on the battery switch to check....the trim ran backwards was my 1st clue I was a dumb@SS...BUT i never turned on the ignition.....never touched...
  15. Dave Abrahamson

    Neat little story...

    The way it's written I can almost see myself there.....(sorry....airplane AND boating nut here....among other things ;) ) Old Aviators and Old Airplanes..... [This is a good little story about a vivid memory of a P-51 and its pilot by a fellow who was 12 years old in Canada in 1967. You may...
  16. Dave Abrahamson

    Sad News out of FL

    Evel Knievel Dies at 69 CLEARWATER, Fla. (AP) -- Evel Knievel, the hard-living motorcycle daredevil whose exploits made him an international icon in the 1970s, died Friday. He was 69. Knievel's death was confirmed by his granddaughter, Krysten Knievel. He had been in failing health for...
  17. Dave Abrahamson

    My trip to Amsterdam...

    Well, my IMPENDING trip to Amsterdam. I'm kinda hoping , in this vast collection of really cool boaters, that some one has embarked on this type of vacation before. I just wanted to know if there were any "never do this" or "never go there" type of advice that I should be aware of. Any advice on...
  18. Dave Abrahamson

    Slow down!!......oops

    I'd love to hear the excuse behind this one! (sorry if it's a repost)
  19. Dave Abrahamson

    Carb linkage bushing? (pic)

    97 Johnson 115 SPL xj115hxeua Doing some routine maintenance under the hood, I noticed some broken pieces laying in the engine pan. I found that they were from the throttle linkage. The top one where the action takes place. I don't know what the part is called, but it appears to be a rubber...
  20. Dave Abrahamson

    Mildewy Life Jackets?

    Anybody know of a good way to get the spots off of life jackets? If I leave them stored in the boat for any length of time, they tend to get mold/mildew type spots on them. Is bleachwater too much to use on them? I don't wanna go to grab 'em one day and find the threads have turned to dust...
Top