Latest activity

Possibly cheaper to find a used Motor, but you could end up with someone else's problem. Rebuilding yours, you would also need to find...

Like this. Yours is small enough that you might just be able to hold it in place, or maybe screw some blocks to the middle to clamp it...

Yes, I know, but that usually occurs while we are using it, or right after we use it. :-) This happened (twice now) without it being...

You realize that an oil injection failure would affect all cylinders, right? You likely have another issue, like a clogged carb, wrong...

when you get the engine is, move that gantry back over to the barn and get busy...

My neighbor had a 17" proline CC. The water would splash up along the hull like most boats, however, the bow rail would deflect the...

The new motor shipped out Monday, so I made a gantry crane from two 30' sticks of 2.375" oil pipe and some scrap 2 inch round tube I...

Ayuh,..... As with 'bout anything mechanical, it works perfectly,... til it don't,...

No. Both times, once it started leaking, it ran out in a pretty noticeable stream. I'm certain it went from no leak to significant leak...

Gen 2 is a little different... it should be a whole housing. I think its the whole cluser of 34-37

Thats not a family boat, that is a project. Walk away from that. Actually run from that. Being new to boating you do not want to start...

OK. I will replace them too. So items 36 and 37 in this diagram.? .

Is it starting leaking, or is it enough time sitting for the slow leak to finally come out of the inlet....

Alcohol resistant fuel lines where mandated by the EPA in 1993 and implemented in the automotive industry in the 1994 model year...

Yes. Probably a good suggestion. So items 19, 20, and 21 in this diagram.? Still can't imagine what would suddenly cause them to just...