Latest activity

Down under humor...someone pass the salt.

2025 Sea Doo watercraft.

Like this. Yours is small enough that you might just be able to hold it in place, or maybe screw some blocks to the middle to clamp it...

Yes

Yes

Don't all Yamaha outboards have an in-line fuse that will prevent power to solenoid? Does the motor have a "dead man" lanyard?

I'm going to experiment with temporary test spray rails, treating each side of the hull like two separate V-hulls. I don't see any...

I just did the brakes on my Tri-axle trailer. In doing so, I also took a look at the bearings. some are better than others. On the...

Don't walk away from the "deal"........RUN!!!!!

OKie dokie. I'm not as familiar with priming system - the intake cap is the line going to the intake manifold?

Can't help you there but you just caused me to recollect another of the reasons I didn't like my tri-hulls....If you were heading N for...

It could be an internal leak. You could try pulling the line that goes to the intake cap It and run it and see if it makes any...

What is that screw for where it says oil?Do I add there or inside?I don't see a drain.

Would I see the leaking after running the motor? At the moment, I don't see any sign of gas around the primer like a leak.

Yes. 122 in both.