Latest activity

I tried it with the primary throttle plate set so there was .020" of transfer slot showing and the secondary open about the same amount...

You should only have primary idle mix screws and not 4-corner. And they should be dead nuts even

agree ,it sometimes will just agree with you ,you have to specify ,what to do now or how do i do something ,if you ask it for reasuring...

I don't know how to use it. I have troubles getting my phone to work. Too many things to fiddle with.

this is how i feel

Could I swap the bowls and jets and use the ‘73 carbs with the ‘77 bowls if I swap the jets out?

thanks for the advice guys, it was the inner prop seal, and i would not have found it if i hadn't rotated the prop shaft directly

If all I did with a vehicle was putter around town, and Electric Vehicle wouldn't be a bad choice. However, that is not the only use for...

The problem I see with electric cars is the costs of battery replacement can easily exceed the value of the vehicle. That is why the...

Hello all! I have an '85 8hp Johnson that will start, idle, and run fine at a slow speed, but will cough and sputter (badly) once the...

Yikes at least get the weight off the prop until you figure it out. Hopefully it’s mot too late.

been doing a lot of tea - it is nice and cheap, i just need a cup or two of coffee in the morning.

I couldn't have made a better case myself for why carburetors suck...lol

sell the bass boat trailer you have and get a real wake board trailer before you bend your prop, prop shaft and strut more than it...