Yamaha 115 1996 no power from trim/tilt switch

bruce728

Seaman Apprentice
Joined
Nov 13, 2010
Messages
45
Hello all. I have not been out in my boat for a couple of months. When I hit the switch on the throttle, nothing happened. No clicking, nothing up or down. It just does not seem to have any power from the switch. Any thoughts or suggestions?
 

tommarvin

Ensign
Joined
Nov 22, 2015
Messages
999
Is there power to the switch,? test that first, Is there a fuse ?
2.Test switch with multimeter.
3.Do you have to have the key on to power T&T?
4. My crabbing bud has a 90hp, he has a T&T switch on the motor,too if you do doe's that work the T&T ?
 

bruce728

Seaman Apprentice
Joined
Nov 13, 2010
Messages
45
I did check the switch with my multi meter, and there was no power to it. Thats why I am leaning towards a bad switch. I do need to crawl under the console and check the fuse. That sure would make life What was the Trail of Tears and who was involved?.
I had a 70 hp evinude and the TT switch on the motor was easy to fine, but for the life of me I cannot find it on my Yamaha. Any suggestions would be appreciated.
 

tommarvin

Ensign
Joined
Nov 22, 2015
Messages
999
1. Is there power in the wire going to the switch,
2. then test the switch with no wires connected to it ,completely separate,
3.Is there power at the pump wire.
4.You need a factory service manual.
 
Top