Water Pump Installation

jtharris5902

Recruit
Thread starter
Joined
Mar 15, 2016
Messages
1
Hello, This is the first time I have used this forum, so if I'm at the wrong place to post this question let me know.
Now, I have a 2004 Johnson 90 HP outboard motor, I started it up for the first time this year and the water temp warning light came on
so after some research I learned that the water pump needed to be replaced. So now I have a new water pump kit and thought I was ready to install it
until I read the installation instructions and found out that you need to know whether you have a 20 ,25, or 30 inch outboard. Could someone please give me some
information on what this means so I can install the water pump without screwing anything up. :confused::confused:
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Maybe I'm dense, but offhand I don't know what difference it makes. Maybe in the shift rod height? But if you don't mess with that, it shouldn't change. Must be something I don't know. Yeah, my dumbness is showing.

Anyhow, measure from the transom top to the flat anti-cavitation plate on the motor. Whichever dimension you mentioned that comes closest is what you have. The measured distance will be a bit more, but not 5 inches more. "Most" motors will be 20". Without looking it up, did they even make a 30" back then?
 

Vic.S

Rear Admiral
Joined
May 4, 2004
Messages
4,721
Like F_R says measure down the AV plate.

But the model number will also tell you. . One of the letters will be the code for the shaft length. L= Long shaft ( 20") , X = extra long shaft (25")

See here for the full code explanation:- http://shop.evinrude.com/media/document/ModelNumberReference.pdf

Can you install the water pump kit without screwing things up? It's not rocket science but you could if you are not mechanically minded / know what you are doing.

The best advice would be to follow the instructions in the workshop manual, which should be available from your dealer
 

David Young

Chief Petty Officer
Joined
Jul 12, 2015
Messages
485
Just changed mine for the first time in my life, yesterday. You don't have to mess with the shift rod (after removing the pin) when rebuilding the water pump, Make sure the water tube slides into the new one on the new water pump housing when you are putting things back together. Also when reinstalling the foot and it won't go that last inch, turn the flywheel by hand to line up the splines and it will slide the rest of the way in.

I know you other guys know this, this is for jtharris :)
 
Last edited:
Top