Water in lower unit.

gramwood

Recruit
Thread starter
Joined
Mar 26, 2010
Messages
1
I recently bought a 1990, 90 hp Force, Spectrum combo. I was told that the motor had not been used since last August but the previous owner said he thought the motor needed a new impeller. Upon draining the lower unit, about a quarter to a half cup of waater came with the lower unit fluid. Will this cause future problems after the impeller change? The lower unit had not been drained for about three years.
Thanks for any input.
 

pnwboat

Rear Admiral
Joined
Oct 8, 2007
Messages
4,251
Re: Water in lower unit.

Water in the lower unit is a problem. Could be something as serious as a bad "O" ring seal or something as simple as a bad gasket on the fill or vent plug.
 

john from md

Commander
Joined
Apr 13, 2008
Messages
2,184
Re: Water in lower unit.

Try filling it up and running it and checking everytime you run it. The best way to check is to let the engine sit for a couple of days and then break the drain plug loose WITHOUT loosening the fill or vent plugs. If there is any water in the lower, it will come out before the oil. Keep the plug close to the hole so you can get it back in quickly.

If there is water or milky oil, you have a leak and need to fix it.

John
 

Smokepole27

Petty Officer 2nd Class
Joined
Jan 12, 2010
Messages
162
Re: Water in lower unit.

Like they said either a fill or drain flug O ring or even (not sure what its call) the bushing like seal that is in front of the prop, youll need a manual to replace that because on some older models they use a spanner wrench to remove the prop shaft spanner nut etc. Just hope you dont have a pin size hole or crack in the foot!
 

ENSIGN

Lieutenant Junior Grade
Joined
Jun 21, 2009
Messages
1,179
Re: Water in lower unit.

pressure test the drive,the leak may be a simple fix.
 
Top