nateintheboat
Recruit
Thread starter- Joined
- Apr 25, 2018
- Messages
- 4
Hi everyone,
Here is where I am at: I have a 1990 Johnson 90HP V4 crossflow flatback with a blown piston - J90TLESB. I am looking at getting a used 1980 powerhead from a 85 HP - J85TLCSA. My plan is to use as many of the parts as I can from the 1990 except for the bad block. All my research says that this will work, but here are my questions:
1. Will this work?
2. Can I use the parts from the 1990 (carbs, ignition, fuel pump, starter, etc.) on the older block?
3. I understand that some of the mounting holes for electronics may not match up. Any advice on how that might work out?
4. I pretty much want to know what I will be in for if I pursue this?
5. The 1980 powerhead is a decent price, but should I holdout for something newer?
Any advice from people who have been down this road would be much appreciated. Thanks.
Here is where I am at: I have a 1990 Johnson 90HP V4 crossflow flatback with a blown piston - J90TLESB. I am looking at getting a used 1980 powerhead from a 85 HP - J85TLCSA. My plan is to use as many of the parts as I can from the 1990 except for the bad block. All my research says that this will work, but here are my questions:
1. Will this work?
2. Can I use the parts from the 1990 (carbs, ignition, fuel pump, starter, etc.) on the older block?
3. I understand that some of the mounting holes for electronics may not match up. Any advice on how that might work out?
4. I pretty much want to know what I will be in for if I pursue this?
5. The 1980 powerhead is a decent price, but should I holdout for something newer?
Any advice from people who have been down this road would be much appreciated. Thanks.