Trying to install a power port(cigarette lighter)

gcrosby111

Cadet
Thread starter
Joined
Sep 21, 2006
Messages
8
I'm trying to install a power port at the console to operate a 2 mill CP spot light...I've got 12 volts at the center hub of the pwr port and the exterior ground connected. The light will not work... i can plug it into the trucks port and it works great...I can also directly connect the port to the battery(at the battery) and it will work, but when I connect at the console, nothing....I've run a pos lead and neg lead from the battery to the console but nothing again.. the indicator light on the spotlight plug comes on as well...any ideas as to why this is happening?
 
Last edited:

Lyle29464

Lieutenant
Joined
Mar 10, 2009
Messages
1,261
Re: Trying to install a power port(cigarette lighter)

Bad connection or bad wire
 

Beefer

Lieutenant Commander
Joined
Aug 4, 2008
Messages
1,737
Re: Trying to install a power port(cigarette lighter)

Have you checked to make sure the battery(s) is charged? You're not blowing the fuse, right? It just won't come on? Does anything else work properly in the power port, or is it just the spot that's not working right? Could also be that the plug for the spotlight may need to be in a certain position to make good contact. I know I've had a few 12v items that if the plug wasn't in just right, it wouldn't work. Wiggle, jiggle, and tweak the plug, and see if that helps.
 

NYBo

Admiral
Joined
Oct 23, 2008
Messages
7,107
Re: Trying to install a power port(cigarette lighter)

What gauge wiring are you using for the run to the console? If it is too small, the voltage drop may be too large.
 
Top