Re: trolling motor
You have a stripped gear in the transmission of your trolling motor. The first drive gear(the on that attaches to the little drive motor) is the on your going to find stripped. What your hearing is that motor running but the gear is stripped. You should have a 3 year warr on that motor.The transmission will need to be replaced. I have fixed these motors when parts were not available, and have not had any problems while the main part was on its way to my shop from Motor Guide. If you take the transmission apart you will see a small white( most are) gear on the motor that drives the left anf right functions. Pry that little gear of of the shaft of the drive motor. Clean the shaft and inside of that gear with ( I use a little of acetone, which is the same as finger nail polish remover that most women have in their homes) to clean any grease or film from the gear and shaft of motor. You will need some RED locktite to coat the shaft and gear. Let dry at least 72 hrs before re-assembly and this should fix until you have an issue again. A new transmission runs about $187.00. I would sure try the repair. Good fishin and keep the dry side up^