Trolling motor wiring question

pre6422hornet

Recruit
Thread starter
Joined
Mar 27, 2009
Messages
1
Hey everyone,

I just upgraded my 12V 55lb motorguide with a Minn Kota 74lb 24V Maxxum. I took the motorguide off and when I looked at the wiring I was perplexed.

There are two wires coming from both the positive and negative posts on my existing deep cycle battery. They run up to the front where they connect to the motorguide plug (female end). Then there are only two wires coming from the plug ( male end) that go to the foot pedal. Now the two wires coming from the battery is 6 gauge. From the male plug to the foot pedal it is 8 gauge.

The minn kota has two wires coming out of the foot pedal and they end in regular battery post terminals. Now I know I need to wire the second deep cycle in a series and run the 60 amp breaker off the positive lead.

So my question is... Do I just eliminate one positive, and one negative wire running up to the bow??

Or can I use the existing female part, and cut the male end off the motorguide, then solder it onto the minn kota???

Any help greatly appreciated.

Pat
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Trolling motor wiring question

What you need to do is follow the directions in the manual and eliminate wires you don't need. This is what a 24 volt system looks like.

24VTrollerWiring.jpg
 
Top