trolling motor boat wiring

mpwielgus

Recruit
Thread starter
Joined
Apr 14, 2009
Messages
1
hello, I own a 85 cheetah 150 bass boat. The plug in the front for the trolling motor has three wires coming out the back of it. One of the wires is black (negative), a red wire with a breaker on it(positive). The question I have is with the third wire it is white and has been cut off and tucked back in the side of the hull. People have told me it could be used to switch the polarity of the trolling motor for foward and reverse but no one seems to be able to tell me where it goes. I am not sure if it should go to the battery or a ground. Can someone please help me out. thanks
 

Wee Hooker

Chief Petty Officer
Joined
Sep 11, 2005
Messages
618
Re: trolling motor boat wiring

That third wire is intended for a 24V system. It's common to cut them back & dead end them for a 12V set-up install. If your running a 12V trolling motor, the connector is wired properly and your all set.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: trolling motor boat wiring

Two wire systems are not for 12 volt motors ONLY. 24 volt ONLY motors also use only two wires. Some boats were wired with two separate circuits (one from each of two batteries) for 12 OR 24 volt trolling motor operation. Some had three wires going up front. I've not seen any newer motors that run on either 12 or 24 volts so only two wires are needed. The third wire would not have been necesary switch polarity. The black and red wires would be swapped for that. Ignore the white wire. You only two wires for 12 or 24 systems. If you have a dual voltage motor than yes, the third wire would be used.
 
Top