I know this has been gone over before but for the life of me, I cannot find the answer. I just replaced my trim limit switch and trim sender. Now I am not getting any feedback on the trim gauge short of it being full trim. my trim up button on my controller does not bring the trim up only the trailer button does. I have tried jumping the trim sender wires at the pump and the trim up button will work. I have tried adjusting the trim limit switch through the entire range of motion with no change. Both of my new switches only had two black wires which were not labeled however if I understand the trim limit switch correctly that shouldn't matter since it's on off. any suggestions of where to go from here would be appreciated.
stats
merc 140 with alpha one gen one
stats
merc 140 with alpha one gen one