Trim Tilt not working Evinrude 115 Ficht

Srdale

Recruit
Thread starter
Joined
Aug 15, 2017
Messages
2
Ive been thru what I believe are all the troubleshooting steps in Seloc for trim and tilt troubleshooting. Everything checks out except the sender and I'm getting ohm readings different from specs in Seloc. My question is even if the sender is bad would that prevent the motor from going up and down? I have a new sender ordered but have my doubts about this being the real problem. Any thoughts or experiences here?
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,328
The trim sender should not affect PTT operation. The trim limit switch will stop trim from running up, but will not affect down trim. I would recommend you locate and disable trim limit switch. On my '98 Johnny, the trim limit switch is on the port side of the tilt tube. The wires to it are blue/white.
 
Top