trim pump runs but no up or down

[kinger952]

pump runs in both directions -- up and down but nothing happens as far as raise or lower - never had this happen before possible sensors ? not sure - any suggestions on where to start looking going to try to bleed this am but dont think that will help ? could be wrong

 

[Bondo]

Ayuh,.... Is there any oil in the pump,..??

 

[tank1949]

pump runs in both directions -- up and down but nothing happens as far as raise or lower - never had this happen before possible sensors ? not sure - any suggestions on where to start looking going to try to bleed this am but dont think that will help ? could be wrong

pull off rams, disconnect fluid lines and see if you can compress piston. Piston/ram may have locked up due to corrosion. I had to totally rebuild all 4 of mine.

 

[kinger952]

That just might be it.
I've took rams off unit and then bled system and not a thing. Now I'm going to pull end caps and see inside

 

[QBhoy]

Yeah. Take the hyd fittings off the end of the ram (carefully, they can suffer corrosion at the inserts into the Ally). See if you can move the rams and see if the pump pumps oil out them open ended. The pump may be relieving and returning to tank if the rams are solid.

 

[kinger952]

Took rams apart like new no corrosion !! Got a hold of a pump I'm thinking weak ? With lines off and hit pump juice pours out up and down so trying this

 

[Drivewayboater2]

While the cylinders are apart you may want to consider rebuilding. Inexpensive and a great sense of security knowing they are rebuilt. Just my 2 cents… hope you find the issue. Good luck

 

[kinger952]

While the cylinders are apart you may want to consider rebuilding. Inexpensive and a great sense of security knowing they are rebuilt. Just my 2 cents… hope you find the issue. Good luck

That don't have a scratch inside and o-rings are like NEW !! I'll wait for that. Thanks