trim and tilt

kt7panther

Recruit
Thread starter
Joined
Jul 16, 2011
Messages
3
Help!! I have an 1992 Evinrude 48 special in which the manual tilt went bad. I had to cut the rod of the old tilt but am having trouble getting the top pin out. The top pin has a cotter pin which I removed to allow it to slide or be driven out however where the pin is makes in nearly impossible to strike a punch on it. The pin has a flat head on the other side which has a threaded hole. Is there a tool designed to remove this pin? How do I get It out? Thanks.
Kenny
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Re: trim and tilt

OMC had a slide hammer puller that the rod on it threaded into the pin to pull it. Are you in fresh or salt water??
 

kt7panther

Recruit
Thread starter
Joined
Jul 16, 2011
Messages
3
Re: trim and tilt

OMC had a slide hammer puller that the rod on it threaded into the pin to pull it. Are you in fresh or salt water??

I'm not sure where the moter has been. I just purchased it. I do see some signs that it may have been in salt water. I have cut the end of the shaft off even with the lug and drove the pin about a 1/2" and then it stopped. I have been heating around the pin and applying penetrent oil. Thanks for the help. I did try pulling the pin using a socket and bolt but the bolt rung off. Now I have another problem to deal with. I'll try drilling and taping and see if I can find one of the puller tools. Thanks again.
Kenny
 
Top