Transom drain plug assembly replacement

[bigjimbok]

I have a 1987 Lund Tyee 4.9. The transom drain has a leak between the collar and the transom. Can anyone advise how to replace the entire assembly and where I would get one?

 

[LippCJ7]

Re: Transom drain plug assembly replacement

garboard plug - iboats

Here you go, Right here on iboats..

not hard to replace, just make sure your transom is ok..

 

[bigjimbok]

Re: Transom drain plug assembly replacement

Thanks for the reply. None of the assemblies match what my old Lund has for a transwom drain. I have a 3/4" rubber t tighten plug and the drain tube it goes into is aluminum with a collar inside and outside. This is what leaks, transom is sound.

 

[LippCJ7]

Re: Transom drain plug assembly replacement

Well I think it would be better for someone more familiar with your setup to comment, and that probably will not take long so Good Luck!

 

[Bob_VT]

Re: Transom drain plug assembly replacement

Seal the collar with 3m5200 ........... The only way it will be replaced is with a welder since it is an aluminum hull.

 

[sublauxation]

Re: Transom drain plug assembly replacement

One of the first two will probably fit and you'll never lose your plug again.
Nylon Drain Plugs - iboats

 

[JoLin]

Re: Transom drain plug assembly replacement

An aluminum boat is problematic because the transom is just thin metal. You could change the type, as in Sub's post above, or you could try this:

Aluminum Boat Transom Drain Tube Kit Stop Leaks for Fishing Row Skiff Jon Deck | eBay

I'd think you could get the flaring tool at a rental place.