FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Whats everyone torquing there head bolts(for the water jacket gasket) down to? couldnt find any specific info in the manual for them so i thought i would play it safe and try 7lbs, ended up snapping a couple.
What motor?? Unless specified otherwise, 1/4" bolts are 60-80 INCH pounds (5-7 foot pounds). Unless I had a super good quality calibrated torque wrench, I'd never use a foot-pound wrench on such small fasteners.
its a 70el79r. I have 4 more screws on order. i can either just get them a little snug by hand or set my $30 torque wrench to 5lbs and pray. givin that some of the bolts did tighten to 7 without issue, i might just try the 5lb route
