TNT manual release screw broken, how can I get it out

[mikeyzx2]

Re: TNT manual release screw broken, how can I get it out

alright I got a screw extractor hope it works, I haven't used it yet I still gotta do a little prepwork before I try it out. I got another issue that could be simple but not sure. I noticed some fluid leaking between the motor and reservoir. I popped it off and sure enough it's gotten inside the motor. I noticed the reservoir has four holes in the top of it, is it likely fluid's coming out of the two holes that aren't used? I need to know before I fry this motor....I'm telling you a new CMC is looking better and better!

 

[Tacklewasher]

Re: TNT manual release screw broken, how can I get it out

Originally posted by mikeyzx2:<br /> goldfish, you could probably find a used pump from salvage yard, and as far as ordering one I know I looked through ishopmarine and big bummer it's listed as N/A, luckily I got my other unit to pick from.

This surprises me. I just got a new o-ring and spring clip from the local dealer and he had one in stock (and showed it to me). It was about $85 Cdn if I remember, but he had one.

 

[mikeyzx2]

Re: TNT manual release screw broken, how can I get it out

tackle, it might be because it's a different setup than what we'er talking about, ours doesn't use a clip, it's a screw with an o-ring and rubber washer

 

[mikeyzx2]

Re: TNT manual release screw broken, how can I get it out

^