Timing question

Znarffsu

Recruit
Thread starter
Joined
Aug 8, 2003
Messages
5
Recently my boat has had an occasional misfire at mid speed and then the boat shuts off. Ive described it as if I am running over rocks but I believe that its just a misfire on my 1996 150hp Ocean Pro Evinrude. Today I popped the hood off and started looking to see if there is anything obviously wrong. <br /><br />On the right side of the motor there is an arm with a roller that opens the carbs once the throttle gets to a certain point. It appears as though this advancement is in sync with the advancing of the timing.<br /><br />What I noticed is that there is a clearish yellow rubber cover over this roller which is split from top to bottom with a large piece missing completely. In my driveway with the motor off I pushed the throttle foward and noticed that this split in the roller allows the roller/bar for the carbs to drop into this split area which means that the carbs are not as open as they normally would be but the timing still advances normally. Could this cause the timing and carbs to be out of synch and could this cause a misfire? Is this bad roller a possibility and is it common?
 

Hooty

Rear Admiral
Joined
Oct 2, 2001
Messages
4,496
Re: Timing question

Yep, it sure can cause a link and sync problem. Replace the plastic roller and see how it runs. Ya may need to do another link & sync adjustment with the new roller. <br /><br />c/6<br /><br />Hooty
 

clanton

Rear Admiral
Joined
Jul 9, 2001
Messages
4,876
Re: Timing question

I dont think it would cause a misfire, but it needs to be replaced, and it is a common problem.
 

Znarffsu

Recruit
Thread starter
Joined
Aug 8, 2003
Messages
5
Re: Timing question

Alright, I just took the torn roller cover completely off and ran her on the lake. I ran WOT, half trottle, idle etc. and had no problems. I put the torn roller back on and ran around also with no problems. The weird thing about this problem is this misfire only happens once in awhile. I took it to a few mechanics and they all say they cant fix whats not broken without stabbing in the dark. Im really getting bummed out because this boat normally goes offshore 25-30 miles. If a power pack is going bad, could it run fine for 99.99% of the time and then run like crap and die? Its a massive misfire that feels like im hitting bottom or something.
 

Hooty

Rear Admiral
Joined
Oct 2, 2001
Messages
4,496
Re: Timing question

You can test the ignition switch, kill switch and wiring harness for a short by disconnecting the large red plug under the cowling, just below the starter. After you've disconnected the plug, jump 12vdc to the small + terminal on the starter solenoid. This will spin the starter and start the engine. Remember though, that starting and running in this mode, the high temp warning, etc. will not be working. Also, the only you'll be able to shut the engine off is to choke it. Operate the boat in this mode for a while and see if the misfire occures. If it doesn't you'll know where the problem isn't. If it does, you'll know where to look.<br /><br />g'luck & c/6<br /><br />Hooty
 

Znarffsu

Recruit
Thread starter
Joined
Aug 8, 2003
Messages
5
Re: Timing question

Im about to replace the powerpack to see if that fixes the problem. Should I replace the optical sensor or are they pretty much bullet proof?
 

Hooty

Rear Admiral
Joined
Oct 2, 2001
Messages
4,496
Re: Timing question

I don,t think your engine has optical sensors. I uses timing coils.<br /><br />c/6<br /><br />Hooty
 
Top