Timing my 73 Johnson 135

rodknee1231

Petty Officer 2nd Class
Thread starter
Joined
Jul 28, 2015
Messages
136
So I just did a rebuild of my motor do I need to time it ? I'm guessing I do. The link in the top secret file had me a tad confused. First thing first I've never timed a motor but I have watched people do it on a car engine and I am mechanically inclined. Second what's it saying I need a spark tester for can't I just hook the light up to #1 and be good? And third if anyone has a good video link that would be awesome
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
The ignition system on this engine needs to have the max timing set when the engine is under load at 5000 rpm's. This is a little tricky for the normal consumer, so there is an alternate timing approach in those "top secret" files at the top of this webpage. You wind up setting the max timing at idle, and then add a correction factor. Usually retarding the max timing a couple of degrees. ( this ignition system will actually creep upward the true timing, the higher the rpm's go. So, if you set it at idle, you need to compensate for what the engine creep timing will actually be at 5000 rpm's.
 

rodknee1231

Petty Officer 2nd Class
Thread starter
Joined
Jul 28, 2015
Messages
136
I'm aware of all that but I'm more hazy on the procedure itself they said I need a spark tester? For what ?
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
You will need a timing light for setting the timing. It will also show the quality of spark on each plugwire-similar to a spark tester.
 

rodknee1231

Petty Officer 2nd Class
Thread starter
Joined
Jul 28, 2015
Messages
136
Also read that you can time these by just cranking it ? Can I leave the plugs in or do need to pull them and keep the fuel connected for lubrication how do I ground the coils if I pulled the plugs so I don't blow a power pack
 
Top