TiltTube Removal -J175EXEUC

4TISQ

Cadet
Thread starter
Joined
Dec 6, 2014
Messages
18
Looking at an exploded view of the Midsection of a 175 hp 1997 Ocean Runner I see nothing that could prevent the Tilt Tube (Item 47) from being removed by tapping on the starboard end with a soft mallet - no way. Can someone give me a clue. Thanks.
 

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
You know that things taking the engine weight so if you knocked it out down the 175hp comes?
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Likely corroded in there from salt water. Could be a bugger to get out.
 

4TISQ

Cadet
Thread starter
Joined
Dec 6, 2014
Messages
18
For sure. I've neglected to say that the powerhead is on my workbench in the garage. Also, I have rigged a sling to support the exhaust hsg/lower unit so the tilt tube has very little pressure. There is some "wiggle" between the starboard stern bracket which suggest the problem is with the port stern bracket. The tilt tube is cataloged as an assembly. I believe the bronze retainer visible on the port end to be threaded onto the tube and it does have an ear to prevent rotation. Could the retainer also be threaded on the OD and be screwed into the ports stern bracket? There is no "wiggle". If not threaded then the stainless steel tube must be corroded and has welded itself to the bracket as you indicated.. Removing the bracket may be my best option? Any suggestions will be appreciated. Thanks.
 
Last edited:

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
I havent had one threaded on to the stern bracket, the retainer and ear is normally the only thing touching the bracket.
Soft mallet wont move much, try hitting with a metal mallet and a bit of wood on the end.
 
Last edited:

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
I haven't tackled one of that model, but the usual procedure is to identify just where it is seized, then heat the aluminum in that area...very hot. Hot as with an acetylene torch. Then beat it out. You will probably destroy any plastic bushings in the area.
 

4TISQ

Cadet
Thread starter
Joined
Dec 6, 2014
Messages
18
Thanks guys, a bigger hammer did the trick....... how about a 3 lb mini sledge. I did insert a hex head. bolt with a flat washer to receive the blow.
 
Top