Snookstalker88
Recruit
Thread starter- Joined
- Feb 25, 2016
- Messages
- 4
I have a mid 80s Johnson 110 that has been off the boat for a year or two. The motor will trim up fine but will only go down if I loosen the pressure relief screw. I am putting power directly to the wires from the t/t motor. As stated goes up fine, but when I reverse the polarity the motor runs but the Rams don't go back down.
What should I be looking for to correct this issue?
Thanks, Dan
What should I be looking for to correct this issue?
Thanks, Dan