Tilt/trim system contamination

michmvp

Recruit
Thread starter
Joined
Jun 15, 2012
Messages
4
Hello,

I have a 1990 Raven with a Mercruiser 3.7 engine and an Alpha 1 outdrive.
I just found out that I have a leak on the starboard lift cylinder. The problem is it's also sucking water. The oil in the reservoir is milky. Once I have addressed the leak, how do I flush the contaminated fluid out of the system?

Any help would be appreciated.

michmvp
 

Don S

Honorary Moderator Emeritus
Joined
Aug 31, 2004
Messages
62,321
Re: Tilt/trim system contamination

There is no easy, quick way to flush it. You take the trim rams off and empty them by pushing the piston in and out and empting the cylinder as much as possible. Blowing all the hoses out with compressed air. The pump has to come apart and the reservoir cleaned out, and the pump flushed with new fluid by running it.
Then put it all back together, bleed it out and go boating.
 

michmvp

Recruit
Thread starter
Joined
Jun 15, 2012
Messages
4
Re: Tilt/trim system contamination

There is no easy, quick way to flush it. You take the trim rams off and empty them by pushing the piston in and out and empting the cylinder as much as possible. Blowing all the hoses out with compressed air. The pump has to come apart and the reservoir cleaned out, and the pump flushed with new fluid by running it.
Then put it all back together, bleed it out and go boating.

Thanks Don. It might be hard but necessary.

michmvp Mike
 
Top