TILT/ TRIM PROBLEMS

Muskie1usa1

Recruit
Thread starter
Joined
Jul 20, 2003
Messages
1
I HAVE 1994 EVINRUDE 150 INTRUDER, THIS WEEKEND WHEN I TOOK IT OUT MY MOTOR LIFTED BY ITSELF AND ONCE THE MOTOR WAS ALL THE UP THE TRIM WOULD NOT SHUT OFF. I HAD TO DISCONECT THE WIRES TO MY REMOTE THROTTLE AND TRIM LEVER FROM UNDER MY ENGINE HOOD. ONCE I DID THAT IT STOPPED THE TRIM FROM CONTINUEING TO RUN... DO I HAVE SHORT?, I ALREADY REPLACED MY RELAYS THAT OPERATE MY TRIM UP AND DOWN... I DONT KNOW WHERE TO GO FROM HERE... THANKS
 

OBJ

Supreme Mariner
Joined
Dec 27, 2002
Messages
10,161
Re: TILT/ TRIM PROBLEMS

Hi Muskie...welcome to iboats.<br /><br />If you have replaced the relays and the problem still is present, you may have a trim switch with the up contacts stuck in the up position. You problably have at least two switches, one on the control handle and one on the engine.....try diconnecting them one at a time. Just disconnect the red power wire to the trim switch should do. If you don't have a service manual, get one. Electrical diagrams are a must if you intend to repair it yourself. Keep us posted...Thanks!
 
Top