tilt/trim on evinrude 135hp

[gibletts]

I have carried out a repair on the trim ram and am ready to reassemble the tilt/trim hydraulic system. It consists of two rams and a pump/reservoir (apprx 100mm dia extenally bolted to rear of engine mounting), I believe the entire assembly is an after market addition to the engine. Question is what is the correct procedure for refilling with hydraulic fluid and flushing / bleeding the system. Many thanks for previous assistance and thanks again in advance for any suggestions.

 

[DJ]

Re: tilt/trim on evinrude 135hp

gibletts,<br /><br />I am assuming that your engine is an early to mid seventies vintage. If so, that sounds like like the factory optional TNT system.<br /><br />Bleed as with any other. Fill with the engine all the way up and locked, rams extended.<br /><br />You will have to keep cycling/filling. Be careful, let the motor cool after a few cycles.<br /><br />Always fill with the engine up, rams extended.