tilt and trim

flatboat fishing

Cadet
Thread starter
Joined
Jul 26, 2016
Messages
7
my trim wont push the motor up . when i pick the motor up by hand and lock it off the bottom 2 rams will go up and down . just wont do it with the weight of the motor on them . any ideas
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Is the fluid level correct in it ?? Is the battery voltage correct ??
 
Last edited:

flatboat fishing

Cadet
Thread starter
Joined
Jul 26, 2016
Messages
7
new battery .and i been adding fluid to it all day . can't get any more in it . think it has bad o rings
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Did you add the fluid in the full tilt position. Then cycle it up and down 5 times ??
 

flatboat fishing

Cadet
Thread starter
Joined
Jul 26, 2016
Messages
7
yes . i can pick the motor up and down by hand without breaking the release screw on the side . that can't be right???
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
Something is wrong if the release screw is fully seated and you can still move the lower unit up/down. Once that emergency release screw is fully seated, the engine should only tilt (move) as a result of the hydraulic pressure of the pump. Are you sure the screw is seated? Is the screw damaged at the tip?
 

flatboat fishing

Cadet
Thread starter
Joined
Jul 26, 2016
Messages
7
thx for responding guys ... got it fixed today .. replaced all the o-rings in the cylinders and it works fine ......
 
Top