Tachometer Testing??

ddrieck

Senior Chief Petty Officer
Thread starter
Joined
Jul 12, 2007
Messages
674
I purchased a Faria tach off eBay that was listed as new. I showed up at the house today and this thing has been installed before. Is there a way to test this tach to see if it works before I go to all the trouble installing it just to find out it doesn't work?

Any Ideas?
Darren
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Tachometer Testing??

What engine are we talking about here. There are two types of tachs. A tach for a two stroke engine will not work on an I/O engine. Most two stroke shift/throttle control boxes have a connector beneath the key for the tach harness. +12v, ground, and send are the three terminals in that connector. If you have the mating harness, attach it to the tach, plug it in and fire the engine. If you have an I/O, you need the same signals, but send comes from the coil, +12v and ground are -- well, +12 and ground so three wires and three small alligator clips will make a temporary test harness.
 

ddrieck

Senior Chief Petty Officer
Thread starter
Joined
Jul 12, 2007
Messages
674
Re: Tachometer Testing??

This is a outboard tach 4, 6, 8 , 10 , and 12 pulse. I wiring it to 1976 Johnson V4 85hp. I just installed the outboard and do not have it all wired as of yet, dang snow.

- I am assuming I should set it to 6 pulse, is this correct?

- Also where do I hook the signal wire? I am using and old Johnson Command Center and it doesn't have the plug on the front like my old Mercury Control

- I was just wonder if there is a way to bench test before installing the Tach?


Darren
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Tachometer Testing??

You can't test it unless you have a signal source such as a signal generator.
 
Top