I just dropped in a new Marine Power v8 sportpac fuel injected motor. The tach was working properly for about 10 hours. My last time out at sea I got some seaweed in my intake that gaused the engine to heat up just a bit hot about 180 and normally runs 160. I kept the engine at about 2000 rpms and limped back to port only about 5 miles. Found the clogged intake, removed debri and engine temp was fine. However the tach went out sometime durring the trip back. Not sure if coinsidence but it just went dead. Reads about 200 when key off then pegs to 0 when key on. So I replaced tach. Still same problem. Checked cylinder switch on back set to 8. Still no tach then I went to wiring. Found the coil with sending wire comming off of it. Hooked tach up directly to that with test wire and tach worked. Then did continuity check. Continuity is fine from engine harness connection to gauge. But when I check from engine harness to coil wire connection it gives me about half conntinuity. So it is a short or bad connection from the coil wire to the engine harness connector. Now this is fuel infected so there is a TON of wire cableing and harness going everywhere. I dont know if the wire goes to the computer then to the harness connectin or what. I am a little apprehensive about tearing into the harnes and following the wire. A buddy has a tone generator of which we are going to try and follow the wire. I could just bypass the engine harness with a direct wire but not sure if this will affect the computer or not. FYI the volt gauge never worked not sure if it was the guage or not.
Is there anything else I could check. fuse, breaker, componet other than wiring. The other odd thing is the wire comming off the coil is brownish in color and it is supposed to be gray. It is gray comming out of the engine harness. But the wiring diagram colors have been wrong before on this engine. The diagram is not that accurate. Any suggestions or things to try before I break into the bundles of wire?
Much Thanks,
Chad
Is there anything else I could check. fuse, breaker, componet other than wiring. The other odd thing is the wire comming off the coil is brownish in color and it is supposed to be gray. It is gray comming out of the engine harness. But the wiring diagram colors have been wrong before on this engine. The diagram is not that accurate. Any suggestions or things to try before I break into the bundles of wire?
Much Thanks,
Chad