System Check Light

Steve Romero

Recruit
Thread starter
Joined
Jul 5, 2003
Messages
3
Hello everyone.I have a problem with the water temp Light that stays on after the system check is performed.I have a 98 150 Johnson.It seem that the light stays on and when i start the motor the buzzard goes off for about 20 sec,and the light still stays on.The motor dosent run hot,and i have full power.The buzzard just goes off when the motor is first started and will not go off again.Unless i turn the motor off and restart it.With the light staying on the hole time.Dose this mean that the temp sensor are bad or do i have a short some where.Can Someone Please Help Me :confused: :confused:
 

clanton

Rear Admiral
Joined
Jul 9, 2001
Messages
4,876
Re: System Check Light

Check the temp sensors wire for short to ground (tan wire), replace tach.
 

Steve Romero

Recruit
Thread starter
Joined
Jul 5, 2003
Messages
3
Re: System Check Light

Thanks for the reply clanton.Im not great at checking thing electrical can you give me more insight on how to check the sensor.And one more thig is that my system check is separate from my tach.is there any way i can check that.
 

seahorse5

Rear Admiral
Joined
Jan 24, 2002
Messages
4,698
Re: System Check Light

A quick check to find out where the problem might be is to disconnect the boat to engine rectangular wiring connector that has the 4 tan wires in it. Then turn the key on to see if the hot lite is still on. If so, then the gauge or the boat harness is bad, if not, then there is a shorted temp switch on one of the cylinder heads, or a shorted wiring harness.
 
Top