Starting problem Johnson 1995 200hp

GurrraG

Recruit
Thread starter
Joined
Jul 19, 2016
Messages
4
I need help since my ideas to find the problem has run out.

Background

I have an wellcraft 218 Coastal equipped with an Johnson 1995 200hp engine. I has always been fairly easy to start but now it wont even ignite. The problem started at the end of last season where I was forced to use starting gas to start it.

Took it out of the water at the end of last season. Checked the engine and pretty fast found a clogged solenoid. Cleaned it and ordered new sealings from ebay. Put everything together and tested the engine on land this season. It started so I thought I had solved last years mystery. Thinking it didnt choke.

Put it in water and it was VERY hard to start. Now it is in the harbour but wont even start. The only times I have managed to start it is when I use almost full throttle and choke. If I get it to start it runs pretty bad, shaking and sounds bad. Dies on idle or even before idle.

This is what I have done

Checked sparks on plugs, blue and nice (the plugs are new)
Tried new fuel from a can to exclude bad/ old gasoline
Checked fuel hoses for leaks
Checked compression, fine
Changed filters (fuel and fuel water separator)
Took carburators of, and cleaned them (took 2 apart to see if they were ok)
Took VRO pump of to see if the membrane was ok
Looked on cables on engine hoping to see any obvious brakes
Took solenoid of cable thinking it mayby was using the choke all the time.


I have run out of ideas. Any suggestions?
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,332
Have you verified that the enrichener (choke) is working? It should have a manual mode, which you can try.
 

GurrraG

Recruit
Thread starter
Joined
Jul 19, 2016
Messages
4
Yes. Tested the solenoid according to manual once I had it off and also tested it manually equipped on engine.
 

GurrraG

Recruit
Thread starter
Joined
Jul 19, 2016
Messages
4
Noting else? Since the season isnt long here i
I would love to fix this asap.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
You said you cleaned the carbs but also said you only took two of them apart. You cannot clean carburetors by spraying stuff through them. They must be totally disassembled, thoroughly cleaned (every passage) and then reassembled with new kits.
 

GurrraG

Recruit
Thread starter
Joined
Jul 19, 2016
Messages
4
Hopefully solved.


It was the solenoid. Even if I did all the test according to the manual ( check ohm, check manual mode, check magnet etc.) the problem was, I think a weak spring at the bottom of the solenoid.

The fuel pressure from the pump was to high that fuel passed solenoid and straight in to the carbs.

I will order a new solenoid and in the mean time try different springs and see if any will do.

Thanks all so far.
 
Top