Natalbany River Rat
Recruit
Thread starter- Joined
- Jun 13, 2016
- Messages
- 3
Hey, everybody.
New to the forums, and to boats in general. Have been a lot of learning the last 2-3 weeks trying to get my Dad's old Johnson running.
It had been sitting for about 17 years. I changed the old hoses and spark plugs. Tested the the spark and it was working. I then cleaned the carb, and used a rebuild kit. Put it in a drum of water and it started 2nd pull. I let it run for a few seconds and then killed it because I knew the water pump and impeller were old and wanted to change that first before I really tried to run it.
I then took the lower unit off and changed the pump pump housing and impeller, plus put new gearcase oil in.Put it in the river and it started 2ndoing or 3rd pull. I wasn't sure how long it would take to start spitting water, so I panicked after 10 seconds and killed it. Went through a mental checklist and just figured it would take longer to start spitting. Wouldn't start for a bunch of pulls. Then got it started a few times and it started spitting (Thank the Lord). However, at this time it would only run for 5-10 seconds and big down and die. Tried it again the next day and it started 2nd pull for about 20 seconds and died. Couldn't get it started again. Came back to Ithe yesterday and it started on first few pulls again. It ran for a few seconds like before and then died again. Then it wouldn't start again after that. It seems to start on the 1st few pulls and then bog out, and not start again. Not really sure what I am doing wrong. It's probably something simple that I'm missing as my experince boat engines is limited. Any help would be greatly appreciated as I wanna get out and get some perch.
New to the forums, and to boats in general. Have been a lot of learning the last 2-3 weeks trying to get my Dad's old Johnson running.
It had been sitting for about 17 years. I changed the old hoses and spark plugs. Tested the the spark and it was working. I then cleaned the carb, and used a rebuild kit. Put it in a drum of water and it started 2nd pull. I let it run for a few seconds and then killed it because I knew the water pump and impeller were old and wanted to change that first before I really tried to run it.
I then took the lower unit off and changed the pump pump housing and impeller, plus put new gearcase oil in.Put it in the river and it started 2ndoing or 3rd pull. I wasn't sure how long it would take to start spitting water, so I panicked after 10 seconds and killed it. Went through a mental checklist and just figured it would take longer to start spitting. Wouldn't start for a bunch of pulls. Then got it started a few times and it started spitting (Thank the Lord). However, at this time it would only run for 5-10 seconds and big down and die. Tried it again the next day and it started 2nd pull for about 20 seconds and died. Couldn't get it started again. Came back to Ithe yesterday and it started on first few pulls again. It ran for a few seconds like before and then died again. Then it wouldn't start again after that. It seems to start on the 1st few pulls and then bog out, and not start again. Not really sure what I am doing wrong. It's probably something simple that I'm missing as my experince boat engines is limited. Any help would be greatly appreciated as I wanna get out and get some perch.