stalls under load

tom27

Recruit
Thread starter
Joined
Jul 21, 2003
Messages
1
I have a 1983 70hp evinrude. The engine starts fine, idles fine, and runs fine at low speed. When I throttle up, the engine will stall. If I gently coax it, I can sometimes get the engine to get past this, and then it accelerates and runs fine. Also, I just discovered that if I press the choke when it's about to stall, it will rev and accelerate fine. This seems to solve the stalling problem most of the time. <br />What does it sound like the problem might be??
 

ob

Admiral
Joined
Aug 16, 2002
Messages
6,992
Re: stalls under load

Fuel restriction in idle low speed orifices or porting ,or idle mix is set a bit too lean.Don't know if that particular model has mix adjustment screws or not.Also your link/synch may be in need of adjustment allowing carbs to open late in relation to timing.
 

Cricket Too

Lieutenant Commander
Joined
May 14, 2003
Messages
1,732
Re: stalls under load

Sounds like maybe one or all of your carbs could be running lean and when you need more fuel under heavier load the carbs are not supplying it, this is probably why the choke will help it to keep from stalling. I would get some rebuild kits and clean and rebuild those carbs. I have that same motor and the carbs are very easy to rebuild. It's probably best not to run it too much until you do the rebuild because a lean running carb can easily burn up a piston head at open throttle, and do some damage even at any speed because a lean condition will cause that aprticular cylinder to run hotter.
 
Top