FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
It's a 90. It drips a little when you cut the motor off then no drip. Thanks for the diagram, and yes the enrichers are what I was referencing. Any thoughts on this motor?
How do I get to the impeller and the fuel filter? I pulled the shroud off last week and cut the tell tale hose short and re-attached it to the fitting. There was a hole in the line inside the shroud spraying water over the electronics. Awesome!. As for the carb rebuild, can I buy kits for my motor. Adjusting them, do I find the highest possible idle and then re-adjust from there?
Seriously, you should buy a manual. Haynes or Seloc are held in distain, but they cover 99% of what a layman or DIY'er needs at a reasonable price. Factory manuals are written for factory trained techs for specific motors. Seloc and Haynes cover many motors.
