Splice into Trolling Motor power

curlyculp

Recruit
Thread starter
Joined
Jun 28, 2009
Messages
1
I have a bow mounted Motorguide 12v. Simple, two-wire system. I'd like to splice an additional power plug for a fishfinder off the tm power cord so when the tm is plugged in I can plug the fishfinder into it's power cord instead of running another power cord the full length of the boat to the battery in back. Will turning the trolling motor on/off cause surges in the power to the fishfinder?
 

JB

Honorary Moderator Emeritus
Joined
Mar 25, 2001
Messages
45,907
Re: Splice into Trolling Motor power

I have a bow mounted Motorguide 12v. Simple, two-wire system. I'd like to splice an additional power plug for a fishfinder off the tm power cord so when the tm is plugged in I can plug the fishfinder into it's power cord instead of running another power cord the full length of the boat to the battery in back. Will turning the trolling motor on/off cause surges in the power to the fishfinder?

Sounds like a plan to me, Curly. Operating the troller shouldn't affect the SONAR unless the wire is too small.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Splice into Trolling Motor power

Is the trolling motor battery in the back of the boat or up front? If it's up front, connect directly to the battery rather than splicing into the troller power cord. You can also feed the locator from any 12v source on the console as that's normally where the fuse panel is located.
 
Top