[SPLASHED] I/O (Sterndrive) Conversion to Outboards

tpenfield

Moderator
Staff member
Joined
Jul 18, 2011
Messages
19,261
It's splashed . . .
.
CY330-Launch-Day4.jpg
.
CY-338-Launch-day.jpg
.
We launched the boat at about 9:00 am today. It was pretty windy, so not much to do but put the boat on the mooring. I put 0.3 hr on the clock, so it is out of its initial break-in phase. The next phase is going up to 2,500 RPM in a varied fashion.
.
The boat sits about 2" higher in the stern than I had anticipated. The static trim appears to be 0.9˚ (just under 1 degree upward) . . . assuming the deck is parallel to the keel. I can probably check that by going off one of the stringers in the bilge.
.
The boat will need an initial cleaning from all the tree trimming it did while bringing the boat up/down our narrow road.
IMG_9904.JPG
.
IMG_9903.JPG
.
 

redneck joe

Supreme Mariner
Joined
Mar 18, 2009
Messages
15,570
when i had the carver and my mind went down this road i contemplated adding 100 or so gallons of fuel capacity in the (former) engine well.
 

tpenfield

Moderator
Staff member
Joined
Jul 18, 2011
Messages
19,261
I had the boat out today for some more break-in running. I was not able to do too much, because one of the trim tabs was in the full down position and would not retract. Later in the day, I was able to fix the trim tab.

I got the engines up to 3200 RPM and a boat speed of 28 mph. and ran the engines at a variety of speeds for about 90 minutes. The boat has very little bow rise coming up on plane.

I also had to do a fair amount of cleaning from all the tree bits/vegetation that fell into while being towed.

Here are a few photos of the day.
.
IMG_9923.JPG
.IMG_9920.JPG
.
IMG_9934.JPG
.
IMG_9940.JPG
.
The engines are very quiet.
.
View attachment IMG_9938.MOV
 
Last edited:
Top