Small hull leak?

cidporter

Recruit
Thread starter
Joined
Aug 11, 2017
Messages
5
Okay so last summer i purchased my first boat, Mckee Craft Tri hull with a dual console... 200$! came with motor and trailer. Got the motor running and now its time to make the boat pretty. There is a tiny dent on the hull, and it slowly drips water. Is there water damage inside my boat? what repairs should i look into doing?
fyi the boat does float lol
 

Scott Danforth

Grumpy Vintage Moderator still playing with boats
Staff member
Joined
Jul 23, 2011
Messages
53,417
for $200..... how many decades old is this boat?
 

jbcurt00

Moderator
Staff member
Joined
Oct 25, 2011
Messages
25,350
I suspect there is more work ahead then you expect or hope....

cant fix the dent til the waters out... then theres the wet float foam to deal w....
 

Scott Danforth

Grumpy Vintage Moderator still playing with boats
Staff member
Joined
Jul 23, 2011
Messages
53,417
McKee Crafts are whaler knockoffs...... and just like a whaler, if the foam is saturated, there is no fixing it.....
 

Lightwin 3

Petty Officer 1st Class
Joined
May 18, 2010
Messages
300
I've rescued more than one water soaked Whaler.

As stated above, you can't fix the dent until the hull is dry.

Here is what I did:

1. Drill some holes, about 3/8" at the lowest point in the transom where you see foam.

2. Attach a wet/dry vacuum to the transom holes with duct tape.

3. Drill corresponding holes in the floor/deck to allow air flow.

Be aware, the hull may produce this water for days or weeks. Just keep at it. It helps to have the hull tilted up as high as possible.

Once you're convinced it's dry, seal the holes with Marine Tex or similar product.
 

Scott Danforth

Grumpy Vintage Moderator still playing with boats
Staff member
Joined
Jul 23, 2011
Messages
53,417
the problem is that if the foam can hold any water, the closed-cell foam has failed and is no longer flotation foam, its a sponge as the cell walls have failed. this comes from long-term exposure to water and freezing. shop vac and duct tape wont generate enough negative pressure to evacuate all the water. even using a vacuum pump for a week you wont get it all out.

only true way to rescue a water soaked whaler is to cut the boat apart and re-foam it. the effort isnt worth it.
 

Lightwin 3

Petty Officer 1st Class
Joined
May 18, 2010
Messages
300
I know where all three of my Old Whalers are and they are doing just fine. One after 15 years.
 
Top